preliminary gan-sic pallet amplifier r tp26030-22 ? tel : 82-31-250-5078 ? all specifications may change without notice. ? rfsales@rfhic.com ? version 0.1 product features application ? doherty amplifier design ? gan on sic hemt ? small and light weight ? 50 ohm input/output impedance matched ? highly reliable and rugged design ? high efficiency, high gain ? 30w typical p av g , 2 path structure(2t) ? lte, wimax dpd amplifier ? general purpose rf amplifier description the RTP26030-22 is designed for rf system application frequencies from 2496mhz to 2690mhz, with high gain. this pallet amplifier uses gan on sic hemt technology wh ich performs high breakdown voltage, high linearity, high efficiency. the RTP26030-22 is dpd application amplifier. electrical specifications @ vdd=+48vdc, t=25 c, 50 system parameter symbol min typ max unit frequency range bw 2496 - 2690 mhz output power p av g - 44.6 dbm instantaneous bandwidth sbw 20 30 mhz output power @ psat g.c.p p sat - 53.4 - dbm small signal gain ssg 50 55 - db small signal gain flatness g - 1.0 1.5 db gain variation gt 3.0 db aclr @ lte 10mhz 1fa 1 aclr -20 -25 dbc aclr with dpd aclr -50 dbc forward coupling level fc 9 10 11 dbm operating voltage 1 vdc1 48 volt operating voltage 2 vdc2 5.6 volt tdd operating voltage vtdd 5.0 volt tdd transition time stdd 0.8 1.2 us chain efficiency 2 @ pout 28.8w ec - 41 - % pallet efficiency @ pout 26.3w ep - 37 - % 1 test signal condition: lte 10mhz 1fa(par 7.5db), test dpd solution: optichron dpd(op6180) 2 chain efficiency is an entire operating transi stor efficiency excluded isolator and coupler. environmental characteristics parameter symbol min typ max unit operating temperature t c -40 - +60 c storage temperature ts -45 - +90 c
preliminary gan-sic pallet amplifier r tp26030-22 ? tel : 82-31-250-5078 ? all specifications may change without notice. ? rfsales@rfhic.com ? version 0.1 mechanical specifications parameter value units limits dimensions ( l x w x h ) 194 x 130 x 20 (2t structure) mm max weight 738 g typical rf connectors in/out/coupling sma female dc connectors / controls 5569-08(8pin), smw200-04p(4pin) cooling external heat sink + airflow rf interface connectors pin # description specifications 1 rf in rf input signal 2 rf out rf output signal 3 rf cpl rf forward detection signal for feed-back dc connector - 5569-08 (4.2mm pitch, 8pin) pin # description specifications 1,2,3 drive, main amp +vdd +48vdc 4 gain block amp +vgg +5.6v 5,6,7,8 gnd ground - smw200-04p (2.0mm pitch, 4pin) pin # description specifications 1 tdd path 0 ttl high enable (+5.0vdc) 2 gnd ground 3 tdd path 1 ttl high enable (+5.0vdc) 4 temp. monitor reporting temperature data [0.75v/25 (10mv/ )] rf connector and dc connector custom design available.
preliminary gan-sic pallet amplifier r tp26030-22 ? tel : 82-31-250-5078 ? all specifications may change without notice. ? rfsales@rfhic.com ? version 0.1 outline drawing
preliminary gan-sic pallet amplifier r tp26030-22 ? tel : 82-31-250-5078 ? all specifications may change without notice. ? rfsales@rfhic.com ? version 0.1 typical output spectrum @ lte 10mhz 1fa (par 7.5db) : pout =26.3w(44.2dbm) - without dpd 2500mhz- - with dpd 2500mhz- - without dpd 2600mhz- - with dpd 2600mhz- - without dpd 2690mhz- - with dpd 2690mhz-
preliminary gan-sic pallet amplifier r tp26030-22 ? tel : 82-31-250-5078 ? all specifications may change without notice. ? rfsales@rfhic.com ? version 0.1 rfhic corporation (rfhic) reserves the right to make changes to any products herein or to discontinue any product at any time w ithout notice. rfhic do not assume any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, inclu ding without limitation consequential or incidental damages. the product specifications herein expressed have been carefully checked and are assumed to be reliable. how ever, rfhic disclaims liability for inaccuracies and strongly recommends buyers to verify that the information they are using is current before placing purchase or ders. rfhic products are not intended for use in life support equipment or application where ma lfunction of the product can be expected to result in persona l injury or death. buyer uses or sells such products for any such unintended or unauthorized applicatio n, buyer shall indemnify, protect and hold rfhic and its direct ors, officers, stockholders, employees, representatives and distributors harmless against any a nd all claims arising out of such use. rfhic?s liability unde r or arising out of damages, claims of whatsoever kind and nature which rfhic p roducts could cause shall be limited in amount to the net p urchase p rice of the p roducts sold to bu y er b y rfhic .
|
